Ford Fusion: Electrical

Accelerator Pedal. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: To prevent setting Diagnostic Trouble Codes (DTCs), make sure the ignition switch is in the OFF position prior to disconnecting the accelerator pedal electrical connector...

Climate Control System

..

Other information:

Ford Fusion 2013–2020 Service Manual: Transmission Fluid Auxiliary Pump. Removal and Installation

Removal With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation). Refer to: Engine Front Undershield (501-02 Front End Body Panels, Removal and Installation). Remove the LH front wheel and tire. Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation). ..

Ford Fusion 2013–2020 Service Manual: Starter Motor Drive Gear and Flywheel Ring Gear Inspection. General Procedures

Inspection Refer to: Starter Motor (303-06A Starting System - 1.5L EcoBoost (118kW/160PS) – I4, Removal and Installation). Check the wear patterns on the starter drive gear and the flywheel or flexplate ring gear. If the wear pattern is normal, then install the starter motor. Refer to: Starter Motor (303-06A Starting System - 1.5L EcoBoost (118kW/160PS) – I4, Removal ..