Ford Fusion: Instrumentation and Warning Systems / Parking Aid - Vehicles With: Active Park Assist

Rear Parking Aid Sensor. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the rear bumper cover. Refer to: Rear Bumper Cover (501-19 Bumpers, Removal and Installation)...

Specifications

  General Specifications - Front Item Specification Active park assist sensor azimuth system check object position 1 (P1) distance from sensor 25 cm (10 in) Active park assist sensor azimuth system check object position 2 (P2) and position 3 (P3) distance from sensor 391 cm (154 in) ± 20 cm (8 in)   Genera..

Other information:

Ford Fusion 2013–2020 Service Manual: Refrigerant System Tests. General Procedures

Inspection NOTE: Procedure 1 — Ambient Temperature below 21 °C (70 °F). NOTE: Proper A/C system diagnosis on a vehicle’s compressor is dependent on correct refrigerant system charge and tested in ambient temperatures above 21°C (70°F). Perform the following steps to achieve normal operating pressures. Drive the vehicle or run the engine until it reaches normal operati..

Ford Fusion 2013–2020 Service Manual: Wheel Knuckle - AWD. Removal and Installation

Special Tool(s) / General Equipment Vehicle/Axle Stands Removal NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fa..