Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the engine appearance cover.
Disconnect the electrical connector, remove the retainer and the MAPT sensor.
Torque:
44 lb.in (5 Nm)
Installation
To install, reverse the removal procedure.
..
Special Tool(s) /
General Equipment
Feeler Gauge
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
NOTE:
Make sure all cylinder head surfaces are clear of
any gasket material, silicone sealant, oil and coolant. The cylinder
head surface must be clean and dry before running a flatness check.
NOTE:
Use a Straightedge that is calibrated by th..