Other information:
Removal
NOTE:
LH side shown, RH side similar.
Remove the rear door window control switch.
Remove the rear door window control switch bezel assembly.
Disconnect the rear door window control switch electrical connector.
NOTE:
This step is only necessary when installing a new component.
Remove the rear door window control s..
Driveshaft runout
1.0 mm (0.040 in)
Driveshaft to PTU joint angle @ curb ride height
5.259 degrees
Driveshaft center bearing "1" joint angle @ curb ride height (Center bearing closest to the PTU)
4.572 degrees
Driveshaft center bearing "2" joint angle @ curb ride height (Center bearing closest to the RDU)
1.635 degrees
Dr..