Ford Fusion: Engine / Engine - 1.5L EcoBoost (118kW/160PS) – I4
Ford Fusion 2013–2020 Service Manual / Powertrain / Engine / Engine - 1.5L EcoBoost (118kW/160PS) – I4
- Specifications
- Engine. Description and Operation
- Engine Component View. Description and Operation
- Engine. Diagnosis and Testing
- Valve Clearance Adjustment. General Procedures
- Camshafts. Removal and Installation
- Camshaft Seal. Removal and Installation
- Crankshaft Front Seal. Removal and Installation
- Crankshaft Rear Seal. Removal and Installation
- Cylinder Head. Removal and Installation
- Engine Mount. Removal and Installation
- Flexplate. Removal and Installation
- Intake Manifold. Removal and Installation
- Oil Cooler. Removal and Installation
Valve Stem Diameter. General Procedures
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
Measure the diameter of each intake and exhaust valve
stem at the points shown...
Specifications
Engine
Item
Specification
Displacement
1.5L Gasoline Turbocharged Direct Injection (GTDI)
No...
Other information:
Ford Fusion 2013–2020 Service Manual: Torque Converter Seal. Removal and Installation
Special Tool(s) / General Equipment 307-003 (T57L-500-B) Holding Fixture, Transmission 307-091Handle, Torque ConverterTKIT-2009TC-F 307-566Retainer, Torque ConverterTKIT-2006C-FFMFLMTKIT-2006C-LMTKIT-2006C-ROW 307-625Fixture, Bench MountingTKIT-2008ET-FLMTKIT-2008ET-ROW 307-627Installer, Converter SealTKIT-2008ET-FLMTKIT-2008ET-ROW Puller Removal ..
Ford Fusion 2013–2020 Service Manual: Front Drive Halfshafts. Diagnosis and Testing
Preliminary Inspection Visually inspect the CV joints, housing, boots, and clamps for obvious signs of mechanical damage. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step If the cause is not visually evident, verify the symptom and REFER to Symptom Chart: NVH. Symptom Chart(s) Diagn..
Categories
- Manuals Home
- 2nd Generation Ford Fusion Owners Manual
- 2nd Generation Ford Fusion Service Manual
- Traction Control
- Front Controls Interface Module (FCIM). Removal and Installation
- Pre-Collision Assist (IF EQUIPPED)
- New on site
- Most important about car
Understanding Your Tire Pressure Monitoring System
The tire pressure monitoring system measures pressure in your road tires and sends the tire pressure readings to your vehicle. You can view the tire pressure readings through the information display. The low tire pressure warning light will turn on if the tire pressure is significantly low. Once the light is illuminated, your tires are under-inflated and need to be inflated to the manufacturer’s recommended tire pressure. Even if the light turns on and a short time later turns off, your tire pressure still needs to be checked.
Copyright © 2026 www.fofusion2.com