Ford Fusion: Engine / Fuel Charging and Controls - 1.5L EcoBoost (118kW/160PS) – I4

Thermostat Housing. Removal and Installation

Special Tool(s) / General Equipment Hose Clamp Remover/Installer Removal NOTE: Removal steps in this procedure may contain installation details...

Fuel Charging and Controls - Component Location. Description and Operation

1.5L EcoBoost Item Description 1 High-pressure fuel pump 2 Fuel injector 3 Fuel rail 4 Throttle Body (TB) 5 High-pressure fuel pump mounting bracket FPDM Item Description 1 FPDM ..

Other information:

Ford Fusion 2013–2020 Service Manual: Refrigerant System Tests - 1.5L EcoBoost (118kW/160PS) – I4. General Procedures

Inspection NOTE: Procedure 1 — Ambient Temperature below 21 °C (70 °F). NOTE: Proper A/C system diagnosis on a vehicle’s compressor is dependent on correct refrigerant system charge and tested in ambient temperatures above 21°C (70°F). Perform the following steps to achieve normal operating pressures. Drive the vehicle or run the engine until it reaches normal operati..

Ford Fusion 2013–2020 Service Manual: Rear Stabilizer Bar. Removal and Installation

Removal NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified. With the vehicle in NEUTRAL, position ..