Ford Fusion: Engine / Starting System - 1.5L EcoBoost (118kW/160PS) – I4

Accessory Drive Belt. Removal and Installation

Special Tool(s) / General Equipment Knife Removal NOTICE: Under no circumstances should the accessory drive belt, tensioner or pulleys be lubricated as potential damage to the belt material and tensioner damping mechanism will occur...

Specifications

  General Specifications Item Specification Normal engine cranking speed (Average) 200-300 Revolutions Per Minute (RPM) Starting circuit maximum voltage drop (Engine at normal operating temperature) (Average) 0...

Other information:

Ford Fusion 2013–2020 Service Manual: Information and Entertainment System. Diagnosis and Testing

DTC Charts ACM DTC Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).   DTC Description Action B150C:01 Automobile Audio Bus (A2B) Node 1: General Electrical Failure  ..

Ford Fusion 2013–2020 Service Manual: Component Bleeding. General Procedures

Special Tool(s) / General Equipment Master Cylinder Bleeding Set Bleeding NOTICE: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water. Master Cylinder NOTE: When a new brake master cylinder has been installed, it should be primed to prevent air from entering the system. NOTE: Make sure the area around the ..