Ford Fusion Manuals

Ford Fusion: Starting System - 1.5L EcoBoost (118kW/160PS) – I4 / Starting System - Overview. Description and Operation

The starting system controls the cranking of the engine. The starter motor is enabled by the starter relay when the relay is activated by the PCM. The PCM receives inputs from the ignition switch - push button start, automatic transmission, Run/start relay and the BCM before activating the starter relay to initiate cranking of the engine.

Starting System - with Remote Start

The remote start system allows the vehicle to be started from up to 50 meters (165 feet) away. For more information on the remote start system, refer to the owners literature and
Refer to: Handles, Locks, Latches and Entry Systems - System Operation and Component Description (501-14 Handles, Locks, Latches and Entry Systems, Description and Operation).

Starting System - with Auto-Start-Stop

The Auto-Start-Stop system helps reduce fuel consumption by automatically shutting off and restarting your vehicle’s engine while the vehicle is stopped. The Auto-Start-Stop system automatically shuts off the engine when the vehicle comes to a complete stop. The engine restarts automatically when you release the brake pedal. In some situations, your vehicle may restart automatically, for example:

  • To maintain interior comfort
  • To recharge the battery

For further information on the Auto-Start-Stop system, REFER to the Owner's Literature and Refer to Powertrain Control/Emissions Diagnosis (PC/ED) manual.

    Specifications

      General Specifications Item Specification Normal engine cranking speed (Average) 200-300 Revolutions Per Minute (RPM) Starting circuit maximum voltage drop (Engine at normal operating temperature) (Average) 0...

    Starting System - System Operation and Component Description. Description and Operation

    System Operation System Diagram Network Message Chart   Module Network Input Messages Powertrain Control Module (PCM) Broadcast Message Originating Module Message Purpose Ignition status   BCM Provides the PCM with ignition mode...

    Other information:

    Ford Fusion 2013–2020 Service Manual: Heated Steering Wheel Module (HSWM). Removal and Installation


    Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: This step is only necessary when installing a new component. NOTE: The PMI process must begin with the current HSWM installed. If the current HSWM does not respond to the diagnostic scan tool, the tool may prompt for As-Built Data as part of the repair...

    Ford Fusion 2013–2020 Service Manual: Seatbelt Retractor and Pretensioner. Removal and Installation


    Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: RH shown, LH similar. Position the front seat in the full forward position.   WARNING: Turn the ignition OFF and wait one minute to deplete the backup power supply...

    Categories

    Adjusting the Steering Wheel

    WARNING: Do not adjust the steering wheel when your vehicle is moving.

    Note: Make sure that you are sitting in the correct position.

    Ford Fusion. Adjusting the Steering Wheel

    Unlock the steering column. Adjust the steering wheel to the desired position.

    read more

    Copyright © 2025 www.fofusion2.com