Ford Fusion: Engine / Engine Ignition - 1.5L EcoBoost (118kW/160PS) – I4

Ford Fusion 2013–2020 Service Manual / Powertrain / Engine / Engine Ignition - 1.5L EcoBoost (118kW/160PS) – I4

Starter Motor. Removal and Installation

Special Tool(s) / General Equipment Strap Wrench Oil Drain Equipment Materials Name Specification Engine Oil - SAE 5W-20 - Synthetic Blend Motor OilXO-5W20-Q1SP WSS-M2C945-B1 Removal WARNING: Always disconnect the battery ground cable at the battery before disconnecting the starter motor battery terminal lead...

Specifications

General Specifications Item Specification Spark plug 12405 Spark plug gap 0...

Other information:

Ford Fusion 2013–2020 Service Manual: Seat Position Sensor. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: RH seat shown, LH seat similar. Remove the screw. Torque: 8 lb.in (0.9 Nm) Disconnect the electrical connector. Remove the seat position sensor...

Ford Fusion 2013–2020 Service Manual: Electronic Parking Brake (EPB) Manual Release. General Procedures

Activation NOTE: If the EPB cannot be released using the switch carry out the following procedure. If the battery is dead, jump start the battery to provide power and release the EPB using the switch. NOTE: Typical parking brake actuator motor shown...

Understanding Your Tire Pressure Monitoring System

Ford Fusion. Understanding Your Tire Pressure Monitoring System

The tire pressure monitoring system measures pressure in your road tires and sends the tire pressure readings to your vehicle. You can view the tire pressure readings through the information display. The low tire pressure warning light will turn on if the tire pressure is significantly low. Once the light is illuminated, your tires are under-inflated and need to be inflated to the manufacturer’s recommended tire pressure. Even if the light turns on and a short time later turns off, your tire pressure still needs to be checked.