Other information:
Removal
NOTICE:
Do not remove or install the M8 nut (20 Nm) on the cable
eyelet bolt while the battery monitoring sensor is attached to the
battery post as this causes damage to the sensor, connector, and
possibly the battery post and case.
Disconnect the battery.
Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
..
Inspection
NOTE:
Procedure 1 — Ambient Temperature below 21 °C (70 °F).
NOTE:
Proper A/C system diagnosis on a vehicle’s
compressor is dependent on correct refrigerant system charge and tested
in ambient temperatures above 21°C (70°F). Perform the following steps
to achieve normal operating pressures.
Drive the vehicle or run the engine until it reaches normal operati..