Ford Fusion: Engine Ignition - 1.5L EcoBoost (118kW/160PS) – I4 / Engine Ignition. Diagnosis and Testing
Diagnostics
in this manual assume a certain skill level and knowledge of
Ford-specific diagnostic practices. For information about these,
REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
For, DTC
For driveability symptoms without DTC, Refer to Powertrain Control/Emissions Diagnosis (PC/ED) manual. See Section 3, Symptom Charts.
System Operation
For System Operation, Refer to Powertrain Control/Emissions Diagnosis (PC/ED) manual. See Section 1 Description and Operation.
Component Description
For
Component Description, Refer to Powertrain Control/Emissions Diagnosis
(PC/ED) manual...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
Use compressed air to remove any foreign material
from the ignition coil-on-plugs and surrounding area before removing the
ignition coil-on-plugs...
Other information:
Removal
NOTICE:
Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
The PMI process must begin with the current VDM installed...
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
NOTE:
Valve guides tend to wear in an hourglass pattern.
The ball gauge can be inserted into the combustion chamber side of the
valve guide, if necessary.
Use a ball gauge to determine the inside diameter of
the valve guides in 2 directions at the top, middle and bottom of the
valve guide...