Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
Disconnect the electrical connector and detach the wiring retainer...
B0001:11, B0001:12, B0001:13 and B0001:1A
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM continuously monitors the driver airbag stage 1 circuits for the following faults:
Resistance out of range
Unexpected voltage
Short to ground
Faulted driver airbag
If a fault is detected, the RCM..