Ford Fusion: Electrical / Electronic Feature Group

Module Programming. General Procedures

Check NOTE: Perform the following pre-checks to make sure module programming completes without errors. NOTE: Starting the engine prior to creating a programming session may prevent certain part number information from being inhaled by the IDS...

Perimeter Anti-Theft Alarm

..

Other information:

Ford Fusion 2013–2020 Service Manual: Starting System - System Operation and Component Description. Description and Operation

System Operation System Diagram Network Message Chart   Module Network Input Messages Powertrain Control Module (PCM) Broadcast Message Originating Module Message Purpose Ignition status   BCM Provides the PCM with ignition mode. Starting System This vehicle is equipped with a PATS that..

Ford Fusion 2013–2020 Service Manual: Brake Vacuum Sensor. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the battery hold down bolt and plate. Torque: 89 lb.in (10 Nm) Position the battery forward. Disconnect the brake vacuum sensor electrical connector. Remove the brake vacuum sensor. ..