Ford Fusion: Battery and Charging System / Voltage Converter/Inverter

Generator Pulley. Removal and Installation

Removal Remove the generator. Refer to: Generator - 1.5L EcoBoost (118kW/160PS) – I4 (414-02 Generator and Regulator, Removal and Installation)...

Direct Current/Alternating Current (DC/AC) Inverter - Component Location. Description and Operation

Item Description 1 Alternating Current (AC) Power Outlet Socket 2 Direct Current/Alternating Current (DC/AC) Inverter ..

Other information:

Ford Fusion 2013–2020 Service Manual: Starter Motor Drive Gear and Flywheel Ring Gear Inspection. General Procedures

Inspection Refer to: Starter Motor (303-06A Starting System - 1.5L EcoBoost (118kW/160PS) – I4, Removal and Installation). Check the wear patterns on the starter drive gear and the flywheel or flexplate ring gear. If the wear pattern is normal, then install the starter motor. Refer to: Starter Motor (303-06A Starting System - 1.5L EcoBoost (118kW/160PS) – I4, Removal ..

Ford Fusion 2013–2020 Service Manual: Exterior Rear Door Handle Reinforcement. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the rear door latch. Refer to: Rear Door Latch (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation). NOTE: This step is only necessary when installing a new component. Remove the cable eyelet from the lever. While turning the release screw the handle..