Ford Fusion: Electrical / Battery and Charging System

Rear Active Park Assist Sensors. Removal and Installation

Removal Remove the rear bumper cover. Refer to: Rear Bumper Cover (501-19 Bumpers, Removal and Installation). Disconnect the electrical connector...

Charging System - General Information

..

Other information:

Ford Fusion 2013–2020 Service Manual: Rear Floor Panel Reinforcement. Removal and Installation

Special Tool(s) / General Equipment 8 mm Drill Bit MIG/MAG Welding Equipment Spot Weld Drill Bit Locking Pliers Removal NOTICE: Battery electric vehicle (BEV), hybrid electric vehicle (HEV) and plug-in hybrid electric vehicle (PHEV) contain a high-voltage battery. Before cutting or welding near the high-voltage battery it must be removed to avoid damage. NOTE: ..

Ford Fusion 2013–2020 Service Manual: Piston Ring End Gap. General Procedures

Special Tool(s) / General Equipment Feeler Gauge Check NOTE: Refer to the appropriate Section 303-01 for the specification. NOTE: Use care when fitting piston rings to avoid possible damage to the piston ring or the cylinder bore. NOTE: Piston rings should not be transferred from one piston to another. NOTE: The cylinder bore must be within specification for ta..