Other information:
Check
NOTE:
Perform the following pre-checks to make sure module programming completes without errors.
NOTE:
Starting the engine prior to creating a programming
session may prevent certain part number information from being inhaled
by the IDS. This may cause programming errors in some modules.
Start the programming session in Key ON Engine OFF.
Make sure the vehicle ..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the rear seat cushion.
Refer to: Rear Seat Cushion (501-10B Rear Seats, Removal and Installation).
Detach and disconnect the LH rear seatbelt buckle electrical connector.
Remove the bolt and position the LH rear seatbelt buckle aside.
Torque:
35 lb.ft (48 Nm)
..