Ford Fusion: Body and Paint / Supplemental Restraint System

Seatbelt Shoulder Height Adjuster. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the B-pillar trim panel. Refer to: B-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...

Airbag and Seatbelt Pretensioner Supplemental Restraint System (SRS) - Component Location. Description and Operation

Item Description 1 Passenger side front impact severity sensor 2 Passenger side seat position sensor 3 OCS sensor 4 Passenger side C-pillar side impact sensor 5 RCM 6 Passenger front door side impact sensor 7 Driver side front impact severity sensor 8 PAD indicator 9 BECMB 10 Driver side seat position s..

Other information:

Ford Fusion 2013–2020 Service Manual: Pinpoint Test - DTC: C. Diagnosis and Testing

B0004:11, B0004:12, B0004:13 and B0004:1A Refer to Wiring Diagrams Cell 46 for schematic and connector information. Normal Operation and Fault Conditions The RCM continuously monitors the driver knee airbag circuits for the following faults: Resistance out of range Unexpected voltage Short to ground Faulted driver knee airbag If a fault is detected, the R..

Ford Fusion 2013–2020 Service Manual: Rear Door Window Regulator Motor. Removal and Installation

Removal Remove the rear door window regulator. Refer to: Rear Door Window Regulator (501-11 Glass, Frames and Mechanisms, Removal and Installation). Remove the rear door window regulator motor. Remove the retainer. Remove the retainers. NOTE: Locating studs must not be removed. Inspect the studs. Installation ..