Ford Fusion: Climate Control System - General Information / Evaporator Temperature Sensor. Removal and Installation

Ford Fusion 2013–2020 Service Manual / Electrical / Climate Control System / Climate Control System - General Information / Evaporator Temperature Sensor. Removal and Installation

Removal

NOTE: Removal steps in this procedure may contain installation details.

WARNING: Before beginning any service procedure in this section, refer to Safety Warnings in section 100-00 General Information. Failure to follow this instruction may result in serious personal injury.
Refer to: Climate Control System Health and Safety Precautions (100-00 General Information, Description and Operation).

NOTE: The evaporator temperature sensor is available only as part of the climate control housing.
Remove the climate control housing - vehicles with: DATC and remove the climate control housing - vehicles with: EMTC.
Refer to: Climate Control Housing - Vehicles With: Dual Automatic Temperature Control (DATC) (412-00 Climate Control System - General Information, Removal and Installation).
Refer to: Climate Control Housing - Vehicles With: Electronic Manual Temperature Control (EMTC) (412-00 Climate Control System - General Information, Removal and Installation).

Installation

Transfer the components from the old housing to the new housing as needed.

To install, reverse the removal procedure.

Evaporator Inlet and Outlet Manifold - 2.7L EcoBoost (238kW/324PS). Removal and Installation

Special Tool(s) / General Equipment Hose Clamp Remover/Installer Removal NOTICE: During the removal or installation of components, cap, tape or otherwise appropriately protect all openings and tubes/fittings to prevent the ingress of dirt or other contamination...

Heater Core. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the climate control housing - vehicles with: DATC. Refer to: Climate Control Housing - Vehicles With: Dual Automatic Temperature Control (DATC) (412-00 Climate Control System - General Information, Removal and Installation)...

Other information:

Ford Fusion 2013–2020 Service Manual: Pinpoint Test - DTC: M. Diagnosis and Testing

B007F:11, B007F:12, B007F:13 and B007F:1A Refer to Wiring Diagrams Cell 46 for schematic and connector information. Normal Operation and Fault Conditions The RCM continuously monitors the passenger seatbelt retractor pretensioner circuits for the following faults: Resistance out of range Unexpected voltage Short to ground Faulted passenger seatbelt retractor p..

Ford Fusion 2013–2020 Service Manual: Body Panel Sectioning. General Procedures

Special Tool(s) / General Equipment Resistance Spotwelding Equipment Spherical Cutter Plasma Cutter Air Body Saw MIG/MAG Welding Equipment Spot Weld Drill Bit Materials Name Specification Seam SealerTA-2-B, 3M™ 08308, LORD Fusor® 803DTM - Repair NOTICE: Do not begin to removal of the vehicle body side until the replacement panel is av..

Using Seatbelts During Pregnancy

WARNING: Always ride and drive with your seatback upright and properly fasten your seatbelt. Fit the lap portion of the seatbelt snugly and low across the hips. Position the shoulder portion of the seatbelt across your chest. Pregnant women must follow this practice. See the following figure.

Ford Fusion. Using Seatbelts During Pregnancy