Other information:
Special Tool(s) /
General Equipment
Feeler Gauge
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
NOTE:
Use a Straightedge that is calibrated by the
manufacturer to be flat within 0.005 mm (0.0002 in) per running foot of
length, such as Snap-On® GA438A or equivalent. For example, if the
Straightedge is 61 cm (24 in) long, the machined edge m..
Removal
Remove the FDIM.
Refer to: Front Display Interface Module (FDIM) (415-00 Information and Entertainment System - General Information - Vehicles With: SYNC 3, Removal and Installation).
Disconnect the electrical connectors and remove the APIM to FDIM cable.
Installation
To install, reverse the removal procedure.
..