Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
When installing a new RCM,
Programmable Module Installation (PMI) is required. Refer to the
diagnostic scan tool instructions to carry out Programmable Module
Installation (PMI).
WARNING:
Turn the ignition OFF and wait one minute to deplete
the backup power supply. Ignition must re..
Check
NOTE:
The object used in this system check can be
fabricated using a 9 cm diameter (3 in I.D.) pipe, 100 cm (39 in) in
length (available as Polyvinyl Chloride (PVC) pipe, or similar from a
hardware or plumbing supply.
NOTE:
The following system check should be carried out with the vehicle on a level surface.
NOTE:
Actual sensor arrangement may differ from the configur..