Other information:
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
Measure the piston diameter 90 degrees from the piston
pin and 41 mm (1.61 in) down from the top of the piston at the point
indicated.
..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
All vehicles
With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
NOTICE:
Route the wheel speed sensor harness as shown or
contact with the wheel speed sensor may occur causing damage ..