Ford Fusion: Body and Paint / Wipers and Washers

Keyless Entry Rear Antenna. Removal and Installation

Removal Open the luggage compartment lid. Release the clips and remove the liftgate scuff plate trim panel. Disconnect the keyless entry rear antenna electrical connector and remove the keyless entry rear antenna...

Wipers and Washers - Overview. Description and Operation

Overview The windshield wiper/washer system is activated by the wiper/washer switch. The windshield wiper/washer system has the following functions and features: Mist wipe Windshield wash Courtesy wipe Windshield wipers (low/high speed) Intermittent wipers Speed dependent wipers Wiper activated exterior lamps Rain sensitive wipers (if equipped) Ther..

Other information:

Ford Fusion 2013–2020 Service Manual: SYNC Module [APIM] to Front Display Interface Module (FDIM) Cable. Removal and Installation

Removal Remove the FDIM. Refer to: Front Display Interface Module (FDIM) (415-00 Information and Entertainment System - General Information - Vehicles With: SYNC 3, Removal and Installation). Disconnect the electrical connectors and remove the APIM to FDIM cable. Installation To install, reverse the removal procedure. ..

Ford Fusion 2013–2020 Service Manual: Cylinder Bore Taper. General Procedures

Check NOTE: Refer to the appropriate Section 303-01 for the specification. Measure the cylinder bore at the top, middle and bottom of piston ring travel in 2 directions as indicated. Verify the cylinder bore is within the wear limit. The difference indicates the cylinder bore taper. If the cylinder bore taper does not meet specification, bore the cylinder to the next oversize lim..