Ford Fusion: Rear Suspension / Rear Suspension - Overview. Description and Operation
Overview
The rear suspension consists of the following components:
-
Coil springs
-
Lower arm and bushing assemblies
-
Shock absorbers
-
Stabilizer bar and links
-
Toe links
-
Upper arms
-
Lower arm vertical links
-
Wheel bearing and wheel hub assemblies
-
Wheel knuckles
-
Wheel studs
Vehicles equipped with Dynamic Suspension:
-
Suspension height sensor
-
Dynamically controlled shock absorbers
Refer to: Vehicle Dynamic Suspension (204-05 Vehicle Dynamic Suspension)
.
The
rear suspension uses 2 parallel arms (1 upper and 1 lower). Each arm
has a mounting position to the chassis and an attachment at the wheel
knuckle. This suspension allows the wheels to react to road
imperfections independent of each other. The shock absorber mounts to
the lower arm and along with the spring, controls vertical movement. The
stabilizer bar and links control suspension lean/sway.
NOTE:
AWD suspension shown, FWD similar.
Item
Description
1
Coil spring
2
Stabilizer and links
3
Shock absorber
4
Wheel knuckle
5
Wheel bearing and wheel hub assembly
6
Wheel studs
7
Lower arm vertical link
8
Toe link
9
Lower arm and bushing assembly
10
Upper arm
11
Suspension height sensor (If equipped with Dy..
Other information:
Special Tool(s) /
General Equipment
205-126
(T78P-4851-A)
Holding Fixture, Drive Pinion Flange
Tire Lever
Materials
Name
Specification
Motorcraft® Silicone Gasket and SealantTA-30
WSE-M4G323-A4
Removal
NOTICE:
When replacing the RDU clutch, the ACT coil and yoke are a matched set and must be replaced also.
NOTICE:
When replacing the RDU clutch, t..
Removal
Remove the fog lamp bezel.
Remove the screws and the fog lamp.
Disconnect the electrical connector.
Installation
To install, reverse the removal procedure.
Adjust the foglamp assembly.
Refer to: Front Fog Lamp Adjustment (417-01 Exterior Lighting, General Procedures).
..