Other information:
Line Pressure Test
NOTE:
Perform the line pressure test prior to performing the stall
speed test. If the line pressure is low at stall, do not perform the
stall speed test or transmission damage will occur. Do not maintain WOT in any transmission range for more than 5 seconds.
This test verifies the line pressure is within specification.
Remove the 2 bolts and position aside the air..
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Open the floor console armrest.
Remove the center trim panel.
Use the General Equipment: Interior Trim Remover
NOTE:
RH side shown, LH side similar.
Both sides.
Rel..