Ford Fusion: Handles, Locks, Latches and Entry Systems / Keyless Entry Rear Antenna. Removal and Installation

Ford Fusion 2013–2020 Service Manual / Body and Paint / Body and Paint / Handles, Locks, Latches and Entry Systems / Keyless Entry Rear Antenna. Removal and Installation

Removal

Open the luggage compartment lid.

Release the clips and remove the liftgate scuff plate trim panel.

Disconnect the keyless entry rear antenna electrical connector and remove the keyless entry rear antenna.

Installation

To install, reverse the removal procedure.

Keyless Entry Keypad. Removal and Installation

Removal NOTE: The keyless entry keypad is serviced with the front door upper moulding. Refer to: Front Door Upper Moulding (501-08 Exterior Trim and Ornamentation, Removal and Installation)...

Wipers and Washers

Other information:

Ford Fusion 2013–2020 Service Manual: Evaporator. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the heater core. Refer to: Heater Core (412-00 Climate Control System - General Information, Removal and Installation). Remove the climate control housing seal. Remove the bolts and the thermostatic expansion valve. Discard the gasket seals. Torque:..

Ford Fusion 2013–2020 Service Manual: Front Suspension - Overview. Description and Operation

Overview The front suspension consists of the following components: Lower arms Stabilizer bar, bushings and links Strut and spring assemblies Wheel bearings Wheel hubs Wheel knuckles Wheel studs Vehicles with Dynamic Suspension: Suspension height sensor Dynamically controlled strut and spring assemblies Refer to: Vehicle Dynamic Suspension ..

Adjusting the Steering Wheel

WARNING: Do not adjust the steering wheel when your vehicle is moving.

Note: Make sure that you are sitting in the correct position.

Ford Fusion. Adjusting the Steering Wheel

Unlock the steering column. Adjust the steering wheel to the desired position.