Ford Fusion Manuals

Ford Fusion: Handles, Locks, Latches and Entry Systems / Keyless Entry Keypad. Removal and Installation

Removal

  1. NOTE: The keyless entry keypad is serviced with the front door upper moulding.

    Refer to: Front Door Upper Moulding (501-08 Exterior Trim and Ornamentation, Removal and Installation).

Installation

  1. To install, reverse the removal procedure.

    Exterior Rear Door Handle Reinforcement. Removal and Installation

    Removal NOTE: Removal steps in this procedure may contain installation details. Remove the rear door latch. Refer to: Rear Door Latch (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation)...

    Keyless Entry Rear Antenna. Removal and Installation

    Removal Open the luggage compartment lid. Release the clips and remove the liftgate scuff plate trim panel. Disconnect the keyless entry rear antenna electrical connector and remove the keyless entry rear antenna...

    Other information:

    Ford Fusion 2013–2020 Service Manual: Starter Motor. Removal and Installation


    Special Tool(s) / General Equipment Strap Wrench Oil Drain Equipment Materials Name Specification Engine Oil - SAE 5W-20 - Synthetic Blend Motor OilXO-5W20-Q1SP WSS-M2C945-B1  Removal   WARNING: Always disconnect the battery ground cable at the battery before disconnecting the starter motor battery terminal lead...

    Ford Fusion 2013–2020 Service Manual: Rear Subframe - FWD. Removal and Installation


    Special Tool(s) / General Equipment 300-OTC1585AEPowertrain Lift Wooden Block Removal NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense...

    Categories

    Fuel Quality

    Choosing the Right Fuel

    Ford Fusion. Fuel Quality

    Your vehicle is designed to operate on regular unleaded gasoline with a minimum pump (R+M)/2 octane rating of 87.

    read more

    Copyright © 2026 www.fofusion2.com