Ford Fusion: Locking and Unlocking / Autolock (If Equipped)
Autolock locks all the doors when all of the
following occur:
- All doors are closed.
- The ignition is on.
- You shift into any gear putting your
vehicle in motion.
- Your vehicle reaches a speed greater
than 12 mph (20 km/h).
Autolock repeats when:
- You open then close any door when
the ignition is on and your vehicle speed
is 9 mph (15 km/h) or lower.
- Your vehicle reaches a speed greater
than 12 mph (20 km/h).
This feature helps to prevent you from
locking your intelligent access key inside
your vehicle’s passenger compartment or
rear cargo area.
When you electronically lock your vehicle
with any door open, the transmission is in
park (P) and the ignition is off, the system
searches for an intelligent access key
inside your vehicle after you close the last
door...
Autounlock
Autounlock unlocks all the doors when all
of the following occur:
The ignition is on, all the doors are
closed, and your vehicle has been
moving at a speed greater than 12 mph
(20 km/h)...
Other information:
Check
NOTE:
If there is a concern with one of the following components
and Bezel Diagnostics cannot be accessed, obtain the module part number
by referencing the label attached to the module.
Inoperative ACM
Inoperative (blank or does not power on) display unit (non-touchscreen display or touchscreen display)
Inoperative FCIM or radio control panel
Inoperative steering w..
B0002:11, B0002:12, B0002:13 and B0002:1A
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM continuously monitors the driver airbag stage 2 circuits for the following faults:
Resistance out of range
Unexpected voltage
Short to ground
Faulted driver airbag
If a fault is detected, the RCM..