Ford Fusion: Brake System / Front Disc Brake

Component Bleeding. General Procedures

Special Tool(s) / General Equipment Master Cylinder Bleeding Set Bleeding NOTICE: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water...

Brake Caliper. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. NOTICE: Brake pads with adhesive on the insulator are one-time use only...

Other information:

News: Ford Recalls Nearly 60,000 Vehicles Including Fusion for Fire Risk

Date: October 16, 2025 Automaker Ford has announced a recall affecting approximately 59,006 vehicles in the United States, among them some units of the Fusion model. The decision follows identification of a fault in the engine block heater which may develop a crack, allowing coolant to leak and possibly trigger a short-circuit under the hood...

Ford Fusion 2013–2020 Service Manual: Refrigerant System Tests - 1.5L EcoBoost (118kW/160PS) – I4. General Procedures

Inspection NOTE: Procedure 1 — Ambient Temperature below 21 °C (70 °F). NOTE: Proper A/C system diagnosis on a vehicle’s compressor is dependent on correct refrigerant system charge and tested in ambient temperatures above 21°C (70°F)...