Ford Fusion: Brake System / Rear Disc Brake

Front Brake Flexible Hose. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details.   WARNING: Before beginning any service procedure in this section, refer to Safety Warnings in section 100-00 General Information...

Brake Caliper. Removal and Installation

Removal NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water...

Other information:

Ford Fusion 2013–2020 Service Manual: Pinpoint Test - DTC: B. Diagnosis and Testing

B0002:11, B0002:12, B0002:13 and B0002:1A Refer to Wiring Diagrams Cell 46 for schematic and connector information. Normal Operation and Fault Conditions The RCM continuously monitors the driver airbag stage 2 circuits for the following faults: Resistance out of range Unexpected voltage Short to ground Faulted driver airbag If a fault is detected, the RCM..

Ford Fusion 2013–2020 Service Manual: Front Display Interface Module (FDIM). Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the FCIM. Refer to: Front Controls Interface Module (FCIM) (415-00C) . Remove the bolts and the FDIM. Torque: 22 lb.in (2.5 Nm) Disconnect the electrical connectors. NOTE: This step is only necessary if replacing the FDIM. ..