Pull the lever toward you to
operate the windshield washers.
When you release the lever, the wipers
operate for a short time. When activated,
a courtesy wipe occurs a short time after
the wipers stop to clear any remaining
washer fluid...
Other information:
B0002:11, B0002:12, B0002:13 and B0002:1A
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM continuously monitors the driver airbag stage 2 circuits for the following faults:
Resistance out of range
Unexpected voltage
Short to ground
Faulted driver airbag
If a fault is detected, the RCM..
Overview
The RCM continually receives and monitors inputs from the OCSM, BECMB and various other hard-wired switches and sensors. If the RCM
detects a sudden vehicle deceleration and/or lateral deceleration based
on the information received from the various sensors, and determines
that deployment is necessary, the RCM applies voltage and current to deploy the appropriate SRS components.
The S..