Ford Fusion Manuals

Ford Fusion: Lighting / Autolamps. Instrument Lighting Dimmer. Headlamp Exit Delay

Ford Fusion 2013–2020 Owners Manual / Lighting / Autolamps. Instrument Lighting Dimmer. Headlamp Exit Delay

Autolamps

WARNING: The system does not relieve you of your responsibility to drive with due care and attention. You may need to override the system if it does not turn the headlamps on in low visibility conditions, for example daytime fog.

Autolamps turn the headlamps on in low light situations or when the wipers operate.

Ford Fusion. Autolamps. Instrument Lighting Dimmer. Headlamp Exit Delay Switch the lighting control to the autolamps position.

The headlamps remain on for a period of time after you switch the ignition off. Use the information display controls to adjust the period of time that the headlamps remain on.

Note: If you switch the autolamps on, you cannot switch the high beams on until the system turns the low beams on.

Windshield Wiper Activated Headlamps

When you switch the autolamps on, the headlamps turn on within 10 seconds of switching the wipers on. They turn off approximately 60 seconds after you switch the windshield wipers off.

The headlamps do not turn on with the wipers:

  • During a single wipe.
  • When using the windshield washers.
  • If the wipers are in intermittent mode.

Note: If you switch the autolamps and the autowipers on, the headlamps turn on when the windshield wipers continuously operate.

Instrument Lighting Dimmer

The instrument lighting dimmer buttons are on the lighting control.

Ford Fusion. Autolamps. Instrument Lighting Dimmer. Headlamp Exit Delay Repeatedly press one of the buttons to adjust the brightness.

Headlamp Exit Delay

After you switch the ignition off, you can switch the headlamps on by pulling the direction indicator lever toward you. You will hear a short tone. The headlamps will switch off automatically after three minutes with any door open or 30 seconds after the last door has been closed. You can cancel this feature by pulling the direction indicator toward you again or switching the ignition on.

    Lighting Control

    Lamps off. Parking lamps, instrument panel lamps, license plate lamps and tail lamps. Headlamps. Headlamp High Beam Push the lever away from you to switch the high beam on...

    Daytime Running Lamps - Vehicles With: Configurable Daytime Running Lamps. Daytime Running Lamps - Vehicles With: Daytime Running Lamps (DRL)

    Daytime Running Lamps - Vehicles With: Configurable Daytime Running Lamps WARNING: The daytime running lamps system does not activate the rear lamps and may not provide adequate lighting during low visibility driving conditions...

    Other information:

    Ford Fusion 2013–2020 Owners Manual: Automatic High Beam Control Indicators. Overriding Automatic High Beam Control


    Automatic High Beam Control Indicators The indicator illuminates to confirm when the system is ready to assist. Overriding Automatic High Beam Control WARNING: The system does not relieve you of your responsibility to drive with due care and attention...

    Ford Fusion 2013–2020 Owners Manual: Cross Traffic Alert Behavior When Trailer is Attached. Switching the System On and Off


    Cross Traffic Alert Behavior When Trailer is Attached Note: The system may not correctly operate when towing a trailer. For vehicles with an approved trailer tow module and tow bar, the system turns off when you attach a trailer. For vehicles with an aftermarket trailer tow module or tow bar, we recommend that you switch the system off when you attach a trailer...

    Categories

    Using Seatbelts During Pregnancy

    WARNING: Always ride and drive with your seatback upright and properly fasten your seatbelt. Fit the lap portion of the seatbelt snugly and low across the hips. Position the shoulder portion of the seatbelt across your chest. Pregnant women must follow this practice. See the following figure.

    Ford Fusion. Using Seatbelts During Pregnancy

    read more

    Copyright © 2022 www.fofusion2.com