Ford Fusion: Lighting / Daytime Running Lamps - Vehicles With: Configurable Daytime Running Lamps.
Daytime Running Lamps - Vehicles With: Daytime Running Lamps (DRL)
Daytime Running Lamps - Vehicles With: Configurable Daytime Running Lamps
WARNING: The daytime running
lamps system does not activate the rear
lamps and may not provide adequate
lighting during low visibility driving
conditions. Make sure you switch the
headlamps on, as appropriate, during all
low visibility conditions. Failure to do so
may result in a crash.
Switch the daytime running lamps on or
off using the information display.
The daytime running lamps turn on when:
- The lamps are on in the information
display.
- You switch the ignition on.
- The transmission is not in park (P) for
vehicles with automatic transmissions
or you release the parking brake for
vehicles with manual transmissions.
- The lighting control is in the autolamps
position.
- The headlamps are off.
The other lighting control switch positions
do not turn on the daytime running lamps.
If the daytime running lamps are off in the
information display, the lamps stay off in
all switch positions.
Daytime Running Lamps - Vehicles With: Daytime Running Lamps (DRL)
WARNING: The daytime running
lamps system does not activate the rear
lamps and may not provide adequate
lighting during low visibility driving
conditions. Make sure you switch the
headlamps on, as appropriate, during all
low visibility conditions. Failure to do so
may result in a crash.
The system turns the lamps on in daylight
conditions.
To switch the system on, switch the
lighting control to any position except
headlamps.
Autolamps
WARNING: The system does not
relieve you of your responsibility to drive
with due care and attention. You may
need to override the system if it does not
turn the headlamps on in low visibility
conditions, for example daytime fog...
Switching the Front Fog Lamps On or Off
Only switch the front fog lamps on during
reduced visibility.
You can switch the front fog lamps on if
any of the following occur:
You set the lighting control to the
parking lamps position...
Other information:
B007F:11, B007F:12, B007F:13 and B007F:1A
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM continuously monitors the passenger seatbelt retractor pretensioner circuits for the following faults:
Resistance out of range
Unexpected voltage
Short to ground
Faulted passenger seatbelt retractor p..
Using MyKey With Remote Start Systems
MyKey is not compatible with non
Ford-approved, aftermarket remote start
systems. If you choose to install a remote
start system, see an authorized dealer for
a Ford-approved remote start system.
MyKey – Troubleshooting
..