Ford Fusion: Lighting / Front Fog Lamps (IF EQUIPPED)
Switching the Front Fog Lamps On or Off
Only switch the front fog lamps on during
reduced visibility.
- You can switch the front fog lamps on if
any of the following occur:
- You set the lighting control to the
parking lamps position.
- You set the lighting control to the
headlamps position.
- You set the lighting control to the
autolamps position and the headlamps
are on.
The front fog lamp button is on the lighting
control.
Press the button to switch the
front fog lamps on or off.
Note: The brightness of the daytime running
lamps may decrease when the front fog
lamps are switched on.
Front Fog Lamp Indicator
It illuminates when you switch
the front fog lamps on.
Daytime Running Lamps - Vehicles With: Configurable Daytime Running Lamps
WARNING: The daytime running
lamps system does not activate the rear
lamps and may not provide adequate
lighting during low visibility driving
conditions...
Direction Indicators
Push the lever up or down to use the
direction indicators.
Note: Tap the lever up or down to make the
direction indicators flash three times to
indicate a lane change...
Other information:
System Operation
System Diagram
Item
Description
1
Hydraulic Pressure Sensor
2
HCU
3
ABS module
4
Hydraulic Pump Motor
5
Brake Booster Vacuum Sensor
6
Wheel Speed Sensors
7
Hydraulic Valve Solenoids
8
GWM
9
RCM
10
PSCM
11
AWD module
12
BCM
13
CCM
14
PCM
..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
WARNING:
Turn the ignition OFF and wait one minute to deplete
the backup power supply. Ignition must remain OFF until repair is
complete. Failure to follow this instruction may result in serious
personal injury or death in the event of an accidental deployment.
If installing a new component ..