Ford Fusion: Driving Aids / Cross Traffic Alert (IF EQUIPPED)
WARNING: Do not use the cross
traffic alert system as a replacement for
using the interior and exterior mirrors or
looking over your shoulder before
reversing out of a parking space. The
cross traffic alert system is not a
replacement for careful driving.
WARNING: The system may not
operate properly during severe weather
conditions, for example snow, ice, heavy
rain and spray. Always drive with due
care and attention. Failure to take care
may result in a crash.
The system alerts you of vehicles
approaching from the sides behind your
vehicle when you shift into reverse (R).
System Errors
If the system detects a fault, a warning
lamp illuminates and a message displays.
Switching the System Off and On
You can switch the system off using the
information display...
The system detects vehicles that approach
at a speed between 4 mph (6 km/h) and
37 mph (60 km/h). Coverage decreases
when the sensors are partially, mostly or
fully obstructed...
Other information:
Special Tool(s) /
General Equipment
308-125Remover, Transfer Case BearingTKIT-1987-LMTKIT-1987-FLM
Slide Hammer
Removal
Remove the intermediate shaft seal.
Refer to: Intermediate Shaft Seal (308-07B Power Transfer Unit - 6-Speed Automatic Transmission – 6F35, Removal and Installation)...
Special Tool(s) /
General Equipment
Resistance Spotwelding Equipment
Hot Air Gun
Air Body Saw
8 mm Drill Bit
MIG/MAG Welding Equipment
Spot Weld Drill Bit
Locking Pliers
Materials
Name
Specification
Seam SealerTA-2-B, 3M™ 08308, LORD Fusor® 803DTM
-
Flexible Foam Repair3M™ 08463, LORD Fusor® 121
-
Removal
Rem..