Ford Fusion: Blind Spot Information System (IF EQUIPPED) / System Errors. Switching the System Off and On
System Errors
If the system detects a fault, a warning
lamp illuminates and a message displays.
Switching the System Off and On
You can switch the system off using the
information display. When you switch
the system off, a warning lamp illuminates
and a message displays. When you switch
the system on or off, the alert indicators
flash twice.
Note: The system remembers the last
setting when you start your vehicle.
Note: The system may not correctly operate
when towing a trailer. For vehicles with a
trailer tow module and tow bar approved
by us, the system turns off when you attach
a trailer. For vehicles with an aftermarket
trailer tow module or tow bar, we
recommend that you switch the system off
when you attach a trailer.
To permanently switch the system off,
contact an authorized dealer.
Vehicles with Automatic Transmission
The system turns on when all of the
following occur:
You start your vehicle.
You shift into drive (D).
The vehicle speed is greater than
6 mph (10 km/h)...
WARNING: Do not use the cross
traffic alert system as a replacement for
using the interior and exterior mirrors or
looking over your shoulder before
reversing out of a parking space...
Other information:
Special Tool(s) /
General Equipment
Interior Trim Remover
8 mm Drill Bit
MIG/MAG Welding Equipment
Spot Weld Drill Bit
Locking Pliers
Materials
Name
Specification
Seam SealerTA-2-B, 3M™ 08308, LORD Fusor® 803DTM
-
Removal
NOTICE:
Battery electric vehicle (BEV), hybrid electric vehicle
(HEV) and plug-in hybrid electric vehicle (PHEV) cont..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
WARNING:
Before beginning any service procedure in this
section, refer to Safety Warnings in section 100-00 General Information.
Failure to follow this instruction may result in serious personal
injury.
Refer to: Climate Control System Health and Safety Precautions (100-00 General Informat..