Ford Fusion: Battery, Mounting and Cables / Generator Current Sensor. Removal and Installation

Ford Fusion 2013–2020 Service Manual / Electrical / Battery and Charging System / Battery, Mounting and Cables / Generator Current Sensor. Removal and Installation

Removal

Disconnect the battery ground.
Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables) .

NOTE: 2.5L shown, other engines similar.

NOTE: Note the orientation and position of the generator current sensor tape tab.
Position the B+ wire protective cover and remove the nut. Index-mark the battery cable at the generator current sensor. Remove and discard the tape securing the generator current sensor to the battery cable and remove the generator current sensor.

Installation

NOTICE: When installing the B+ terminal nut to the generator, finger-start the nut before tightening or component damage may occur.

NOTE: 2.5L shown, other engines similar.

NOTE: The generator current sensor must be installed in the proper position and orientation to function correctly.
With the generator current sensor tape tab pointing away from the generator, position the generator current sensor to the index-mark on the battery cable and secure with electrical tape. Install the nut and position the B+ wire protective cover.
Torque: 150 lb.in (17 Nm)

Connect the battery ground.
Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables) .

Battery Tray. Removal and Installation

Removal Vehicles without Auto-Start-Stop System Remove the air cleaner. Refer to: Air Cleaner (303-12B Intake Air Distribution and Filtering - 2...

Generator and Regulator

Other information:

Ford Fusion 2013–2020 Service Manual: Intermediate Clutch Assembly. Diagnosis and Testing

Intermediate Clutch For intermediate (2,6) clutch operation, REFER to: Transmission Description - System Operation and Component Description (307-01A Automatic Transmission - 6-Speed Automatic Transmission – 6F35, Description and Operation). REFER to: Intermediate Clutch Assembly (307-01A Automatic Transmission - 6-Speed Automatic Transmission – 6F35, Description and Operation). &nb..

Ford Fusion 2013–2020 Service Manual: Electronic Parking Brake (EPB) Manual Release. General Procedures

Activation NOTE: If the EPB cannot be released using the switch carry out the following procedure. If the battery is dead, jump start the battery to provide power and release the EPB using the switch. NOTE: Typical parking brake actuator motor shown. Block the wheels and tires. Disconnect the parking brake actuator motor electrical connector and, if equipped, de..

Adjusting the Steering Wheel

WARNING: Do not adjust the steering wheel when your vehicle is moving.

Note: Make sure that you are sitting in the correct position.

Ford Fusion. Adjusting the Steering Wheel

Unlock the steering column. Adjust the steering wheel to the desired position.