Ford Fusion: Cruise Control / Cruise Control - Overview. Description and Operation
Overview
The cruise control system is controlled by the PCM.
The cruise control mode is selected from the steering wheel mounted switches (ON/OFF, SET+, SET- and CAN/RES), which are integrated into the LH steering wheel switch.
For vehicles equipped with adaptive cruise control, the gap setting is selected from the steering wheel mounted switch <---> (GAP increase) and <-> (GAP decrease), which are integrated into the LH steering wheel switch.
The cruise control system maintains a selected vehicle speed between 32 km/h (20 mph), or 29 km/h (18 mph) (metric cluster), and the maximum limited vehicle speed. When a MyKey® restricted key is in use and max speed limiter is turned on, vehicle speed is limited to 129 km/h (80 mph).
During normal driving, the vehicle speed can vary slightly from the set speed due to road conditions. The vehicle speed can fluctuate when driving up and down a steep hill. If the vehicle speed decreases more than 16 km/h (10 mph) below the set speed, the cruise control disengages.
Cruise Control - System Operation and Component Description. Description and Operation
System Operation
Non-Adaptive Cruise Control
Item
Description
1
Brake switch assembly
2
IPC
3
Accelerator pedal
4
Deactivator switch
5
Stoplamp switch
6
SCCM
7
PCM
8
Cruise control switches
9
GWM
10
ABS module
11
RCM
Network Message Chart
Network Input Messages - Instrum..
Other information:
Ford Fusion 2013–2020 Service Manual: Pinpoint Test - DTC: B. Diagnosis and Testing
B0002:11, B0002:12, B0002:13 and B0002:1A Refer to Wiring Diagrams Cell 46 for schematic and connector information. Normal Operation and Fault Conditions The RCM continuously monitors the driver airbag stage 2 circuits for the following faults: Resistance out of range Unexpected voltage Short to ground Faulted driver airbag If a fault is detected, the RCM..
Ford Fusion 2013–2020 Service Manual: Elevation System Check. General Procedures
Check Turn the ignition ON, engine OFF. Set the parking brake. Place the gearshift in REVERSE (R) for rear parking aid sensors. Place the gearshift in DRIVE (D) for front parking aid sensors. Using a diagnostic scan tool, monitor the parking aid sensor distance Parameter Identifications (PIDs) to verify no objects are dete..
Categories
- Manuals Home
- 2nd Generation Ford Fusion Owners Manual
- 2nd Generation Ford Fusion Service Manual
- Engine
- Automatic Transmission - 6-Speed Automatic Transmission – 6F35
- Cylinder Head. Removal and Installation
- New on site
- Most important about car
Parallel Parking
The system detects available parallel parking spaces and steers your vehicle into the space. You control the accelerator, gearshift and brakes. The system visually and audibly guides you into a parallel parking space.
Press the button once to search
for a parking space.
