Ford Fusion: Glass, Frames and Mechanisms / Rear Door Window Regulator Motor. Removal and Installation
Removal
-
Remove the rear door window regulator.
Refer to: Rear Door Window Regulator (501-11 Glass, Frames and Mechanisms, Removal and Installation).
-
Remove the rear door window regulator motor.
-
Remove the retainer.
-
Remove the retainers.
-
NOTE:
Locating studs must not be removed.
Inspect the studs.
Installation
-
To install, reverse the removal procedure.
-
Perform the power door window initialization.
Refer to: Power Door Window Initialization (501-11 Glass, Frames and Mechanisms, General Procedures).
Special Tool(s) /
General Equipment
Adhesive Tape
Removal
NOTE:
LH side shown, RH side similar.
NOTE:
Removal steps in this procedure may contain installation details...
Removal
NOTE:
LH side shown, RH side similar.
NOTE:
Removal steps in this procedure may contain installation details.
Remove the rear door window glass...
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the cap.
Remove the RH side Fender Splash Shield.
Refer to: Fender Splash Shield (501-02 Front End Body Panels, Removal and Installation)...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
WARNING:
Before beginning any service procedure in this
section, refer to Safety Warnings in section 100-00 General Information.
Failure to follow this instruction may result in serious personal
injury...