Ford Fusion Manuals

Ford Fusion: Glass, Frames and Mechanisms / Power Door Window Initialization. General Procedures

Ford Fusion 2013–2020 Service Manual / Body and Paint / Body and Paint / Glass, Frames and Mechanisms / Power Door Window Initialization. General Procedures

Initialization

  1. Ford Fusion. Power Door Window Initialization. General Procedures  WARNING: Before beginning any service procedure in this section, refer to Safety Warnings in section 100-00 General Information. Failure to follow this instruction may result in serious personal injury.

    Refer to: Health and Safety Precautions (100-00 General Information, Description and Operation).
  1. Ford Fusion. Power Door Window Initialization. General Procedures  WARNING: Keep objects and body parts clear of the glass panel when carrying out the initialization procedure. During the initialization procedure, the glass panel closes with high force and cannot detect objects in its path. Failure to follow this instruction may result in serious personal injury.

    NOTE: Make sure that the window runs are correctly installed and free of foreign material.

    Start the engine.
  1. Press and hold the window control switch until the door window is fully open.
  1. Release the window control switch.
  1. Lift and hold the window control switch until the door window is fully closed.
  1. Release the window control switch.
  1. Lift and hold the window control switch again for at least one second.
  1. Press and hold the window control switch until the door window is fully open.
  1. Release the window control switch.
  1. Lift and hold the window control switch until the window is fully closed.
  1. Test for correct window operation by carrying out the one-touch down and one-touch up features.

    Lead Terminal Repair. General Procedures

    Materials Name Specification Motorcraft® Ultra-Clear Spray Glass CleanerZC-23 ESR-M14P5-A  Repair   WARNING: Before beginning any service procedure in this section, refer to Safety Warnings in section 100-00 General Information...

    Front Door Window Glass. Removal and Installation

    Removal NOTE: LH side shown, RH side similar. Remove the front door trim panel. Refer to: Front Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...

    Other information:

    Ford Fusion 2013–2020 Service Manual: Heater Core Leak Check - Vehicles With: R1234YF Refrigerant. General Procedures


    Inspection NOTE: A coolant leak in the heater hose could follow the heater core tube to the heater core and appear as a leak in the heater core. Inspect for evidence of coolant leakage at the heater hose to heater core attachments. NOTE: Spring-type clamps are installed as original equipment...

    Ford Fusion 2013–2020 Service Manual: Side Obstacle Detection Control Module. Removal and Installation


    Removal NOTE: SODL is shown, SODR is similar. NOTE: If installing a new SODL or SODR, it is necessary to upload the module configuration information to the scan tool prior to removing the module. This information must be downloaded into the new SODL or SODR after installation...

    Categories

    Using Seatbelts During Pregnancy

    WARNING: Always ride and drive with your seatback upright and properly fasten your seatbelt. Fit the lap portion of the seatbelt snugly and low across the hips. Position the shoulder portion of the seatbelt across your chest. Pregnant women must follow this practice. See the following figure.

    Ford Fusion. Using Seatbelts During Pregnancy

    read more

    Copyright © 2025 www.fofusion2.com