Ford Fusion Manuals

Ford Fusion: Passive Anti-Theft System (PATS) / Key Programming Using Two Programmed Keys. General Procedures

Ford Fusion 2013–2020 Service Manual / Electrical / Electronic Feature Group / Passive Anti-Theft System (PATS) / Key Programming Using Two Programmed Keys. General Procedures

Programming

NOTE: This procedure works only if the spare key programming is enabled.

NOTE: Two previously programmed keys are required to perform this procedure. All the steps must be completed within 30 seconds.

NOTE: Make sure all the doors are closed prior to beginning this procedure and they remain closed until the procedure is complete.

  1. Locate the passive key backup starting location. Refer to the Owner Literature for the passive key backup starting location.
  1. Place the first programmed passive key in the backup starting location. Press the START/STOP button.
  1. Wait 5 seconds and then press the START/STOP button.
  1. Remove the first previously programmed passive key.
  1. Within 10 seconds, place the second previously programmed passive key in the backup starting location and press the START/STOP button.
  1. Wait 5 seconds and press the START/STOP button.
  1. Remove the second previously programmed passive key.
  1. NOTE: See the Owner's Literature for maximum number of keys that can be programmed to the vehicle.

    Wait 5 seconds and then place the unprogrammed passive key in the backup starting location and press the START/STOP button.
  1. NOTE: If the key does not successfully program, wait at least 10 seconds before attempting to repeat the procedure.

    Verify the RKE transmitter operates and the vehicle starts using the new passive key.

    Anti-Theft Key Programming - Scan Tool. General Procedures

    Programming NOTE: Make sure the passive key battery(ies) measure at least 2.5 volts. A passive key with a depleted battery only starts the vehicle when in the backup starting location...

    Passive Anti-Theft System (PATS) Center Antenna. Removal and Installation

    Removal NOTE: Removal steps in this procedure may contain installation details. Open the floor console stowage bin lid. On both sides...

    Other information:

    Ford Fusion 2013–2020 Service Manual: Fuel Filler Door Spring. Removal and Installation


    Special Tool(s) / General Equipment Flat Headed Screw Driver Removal Open the fuel filler door. Press the tab to release the fuel filler door spring from the fuel filler door assembly. Use the General Equipment: Flat Headed Screw Driver Installation To install, reverse the removal procedure...

    Ford Fusion 2013–2020 Service Manual: Body Control Module (BCM). Removal and Installation


    Special Tool(s) / General Equipment Interior Trim Remover Removal All vehicles NOTE: Removal steps in this procedure may contain installation details. NOTE: If the BCM did not respond to the diagnostic scan tool, As-Built Data may need to be entered as part of the repair...

    Categories

    Direction Indicators. Interior Lamps

    Direction Indicators

    Ford Fusion. Direction Indicators. Interior Lamps

    Push the lever up or down to use the direction indicators.

    read more

    Copyright © 2025 www.fofusion2.com