Ford Fusion: Horn / Horn - Overview. Description and Operation
Ford Fusion 2013–2020 Service Manual / Electrical / Instrumentation and Warning Systems / Horn / Horn - Overview. Description and Operation
Overview
The BCM controls horn output by energizing the integrated horn relay located in the BJB and sounding the horn.
Horn - System Operation and Component Description. Description and Operation
System Operation
System Diagram
Item
Description
1
BJB
2
Horn Relay
3
Horn Switch
4
Clockspring
5
SCCM
6
BCM
7
Horn
Horn Operation
The
horn switch consists of 2 sets of contacts separated by springs...
Other information:
Ford Fusion 2013–2020 Service Manual: Transport Mode Deactivation. General Procedures
Deactivation NOTE: After vehicle build, some vehicle modules are set in Transport mode including the IPC and the BCM. Transport mode reduces battery drain during longer periods where the vehicle is not used. While in transport mode, the IPC displays TRANSPORT MODE CONTACT DEALER in the message center...
Ford Fusion 2013–2020 Service Manual: Key Programming Using Two Programmed Keys. General Procedures
Programming NOTE: This procedure works only if the spare key programming is enabled. NOTE: Two previously programmed keys are required to perform this procedure. All the steps must be completed within 30 seconds. NOTE: Make sure all the doors are closed prior to beginning this procedure and they remain closed until the procedure is complete...
Categories
- Manuals Home
- 2nd Generation Ford Fusion Owners Manual
- 2nd Generation Ford Fusion Service Manual
- Traction Control
- Garage Door Opener
- Body Control Module (BCM). Removal and Installation
- New on site
- Most important about car
Understanding Your Tire Pressure Monitoring System
The tire pressure monitoring system measures pressure in your road tires and sends the tire pressure readings to your vehicle. You can view the tire pressure readings through the information display. The low tire pressure warning light will turn on if the tire pressure is significantly low. Once the light is illuminated, your tires are under-inflated and need to be inflated to the manufacturer’s recommended tire pressure. Even if the light turns on and a short time later turns off, your tire pressure still needs to be checked.
Copyright © 2026 www.fofusion2.com