Ford Fusion: Glass, Frames and Mechanisms / Front Door Window Regulator Motor. Removal and Installation
Removal
-
Remove the front door window regulator.
Refer to: Front Door Window Regulator (501-11 Glass, Frames and Mechanisms, Removal and Installation).
-
Remove the front door window regulator motor.
-
Remove the retainer.
-
Remove the retainers.
-
NOTE:
Locating studs must not be removed.
Inspect the studs.
Installation
-
To install, reverse the removal procedure.
-
Perform the power door window initialization.
Refer to: Power Door Window Initialization (501-11 Glass, Frames and Mechanisms, General Procedures).
Removal
Remove the front door trim panel.
Refer to: Front Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...
Special Tool(s) /
General Equipment
Adhesive Tape
Removal
NOTE:
LH side shown, RH side similar.
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
System Operation
System Diagram
Item
Description
1
ACM
2
HUD module
3
CCM
4
IPC
5
BCM
6
GWM
7
ABS module
8
IPMA
Network Message Chart
Network Input Messages - ACM
Broadcast Message
Originating Module
Message Purpose
Instrument ..
Materials
Automatic Transmission
Note: Automatic transmissions that require
MERCON® LV transmission fluid should
only use MERCON® LV transmission fluid.
The use of any other fluid could cause
transmission damage.
Capacities
1 Approximate dry fill capacity. Actual amount may
vary during fluid changes.
Materials
Engine Coolant
Capacities
An oil that displays this symbol conforms
to cu..