Ford Fusion: Wheels and Tires
Ford Fusion 2013–2020 Owners Manual / Wheels and Tires
The recommended tire inflation pressures are on the tire information label on the driver side B-pillar.
Check and set the tire pressure at the ambient temperature in which you are intending to drive your vehicle and when the tires are cold.
Note: Check your tire pressures regularly to optimize fuel economy.
This option is available in all states. California apostille. Florida apostille.Installation of any tires that are not the original equipment tire size can cause the speedometer to display incorrect vehicle speed.
- Tire Care
- Using Summer Tires. Using Snow Chains
- Tire Pressure Monitoring System
- Changing Tires With a Tire Pressure Monitoring System
- Understanding Your Tire Pressure Monitoring System
- Changing a Road Wheel
- Dissimilar Spare Wheel and Tire Assembly Information
- Changing a Road Wheel Procedure
- Stowing the Flat Tire Without the Retainer Strap
- Stowing the Flat Tire Using the Retainer Strap (If Equipped)
- Technical Specifications - 1.5L EcoBoost™/2.0L EcoBoost™/2.5L
- Technical Specifications - 2.7L EcoBoost™
Vehicle Storage. Body Styling Kits
Vehicle Storage
If you plan on storing your vehicle for 30
days or more, read the following
maintenance recommendations to make
sure your vehicle stays in good operating
condition...
Tire Care
Important information for
235/40R19 low-profile tires
and wheels If your vehicle is
equipped with 235/40R19 tires,
they are low-profile tires. These
tires and wheels are designed to
give your vehicle a sport
appearance...
Other information:
Ford Fusion 2013–2020 Service Manual: Passive Anti-Theft System (PATS). Diagnosis and Testing
DTC Charts Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation). BCM DTC Chart DTC Description Action B10C7:01 Interior Trunk Antenna: General Electrical Failure ..
Ford Fusion 2013–2020 Service Manual: Module Configuration - System Operation and Component Description. Description and Operation
System Operation Module Programming Menu Module Programming is listed under the Toolbox tab after starting an IDS session with a vehicle. The module programming menu is disabled when a manual vehicle session is created. The Module Programming menu has 4 selections: Programmable Module Installation (PMI) Module Reprogramming Programmable Parameters As-Built These selec..
Categories
- Manuals Home
- 2nd Generation Ford Fusion Owners Manual
- 2nd Generation Ford Fusion Service Manual
- Transmission - 1.5L EcoBoost (118kW/160PS) – I4. Removal and Installation
- Main Control Valve Body. Removal and Installation
- Garage Door Opener
- New on site
- Most important about car
Power Door Locks
The power door lock control is on the driver and front passenger door panels.
Copyright © 2026 www.fofusion2.com