Ford Fusion: Wheels and Tires / Changing a Road Wheel
WARNING: If the tire pressure
monitor sensor becomes damaged it
may not function.
Note: The tire pressure monitoring system
indicator light illuminates when the spare
tire is in use. To restore the full function of
the monitoring system, mount all road
wheels equipped with tire pressure
monitoring sensors on the vehicle.
Note: You should only use tire sealants in
roadside emergencies as they may cause
damage to the tire pressure monitoring
system sensor.
If you get a flat tire when driving, do not
apply the brake heavily. Instead, gradually
decrease your speed. Hold the steering
wheel firmly and slowly move to a safe
place on the side of the road.
Have a flat serviced by an authorized
dealer to prevent damage to the tire
pressure monitoring system sensors. Replace the spare tire with a road tire
as soon as possible. During repairing or
replacing of the flat tire, have an authorized
dealer inspect the tire pressure monitoring
system sensor for damage.
The tire pressure monitoring system
measures pressure in your road tires and
sends the tire pressure readings to your
vehicle. You can view the tire pressure
readings through the information display...
WARNING: Failure to follow these
guidelines could result in an increased
risk of loss of vehicle control, injury or
death.
If you have a dissimilar spare wheel and
tire, use it for temporary use only...
Other information:
DTC Chart: BCM
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
BCM
DTC Chart
DTC
Description
Action
B124A:11
Right Daytime Running Light: Circuit Short to Ground
GO ..
Special Tool(s) /
General Equipment
307-581Manual lever seal installerTKIT-2006UF-FLMTKIT-2006UF-ROW
Flat Headed Screw Driver
Removal
Remove the TR sensor.
Refer to: Transmission Range (TR) Sensor (307-01A Automatic Transmission - 6-Speed Automatic Transmission – 6F35, Removal and Installation).
Remove and discard the selector shaft seal.
Use the..