Ford Fusion Manuals

Ford Fusion: Automatic Transmission - 6-Speed Automatic Transmission – 6F35 / Transmission Fluid Exchange. General Procedures

Materials

Name Specification
Motorcraft® MERCON® LV Automatic Transmission Fluid
XT-10-QLVC
WSS-M2C938-A
MERCON® LV,
 

Connect

  1. With the vehicle in NEUTRAL, position it on a hoist.
    Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
    Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
    Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
  1. Use the Fluid Exchanger to change the fluid.
    Material: Motorcraft® MERCON® LV Automatic Transmission Fluid / XT-10-QLVC (WSS-M2C938-A) (MERCON® LV, )
  1. Connect the Fluid Exchanger to the transmission fluid cooler tube after the transmission fluid cooler on the return tube. This will help remove any foreign material trapped in the transmission fluid coolers.
  1. Perform the transmission fluid exchange using the Fluid Exchanger. Follow the manufacturer's instructions included with the machine.
  1. Once the transmission fluid exchange is completed, disconnect the Fluid Exchanger. Reconnect any disconnected transmission fluid cooler tubes.
  1. Check the transmission fluid level.
    Refer to: Transmission Fluid Level Check (307-01A Automatic Transmission - 6-Speed Automatic Transmission – 6F35, General Procedures).
    Refer to: Transmission Fluid Level Check (307-01A Automatic Transmission - 6-Speed Automatic Transmission – 6F35, General Procedures).

    Transmission Fluid Drain and Refill. General Procedures

    Materials Name Specification Motorcraft® MERCON® LV Automatic Transmission FluidXT-10-QLVC WSS-M2C938-AMERCON® LV,   Draining With the vehicle in NEUTRAL, position it on a hoist...

    Transmission Fluid Level Check. General Procedures

    Materials Name Specification Motorcraft® MERCON® LV Automatic Transmission FluidXT-10-QLVC WSS-M2C938-AMERCON® LV,   Check Connect the diagnostic scan tool to the vehicle...

    Other information:

    Ford Fusion 2013–2020 Service Manual: Piston Diameter. General Procedures


    Check NOTE: Refer to the appropriate Section 303-01 for the specification. Measure the piston diameter 90 degrees from the piston pin and 41 mm (1.61 in) down from the top of the piston at the point indicated. ..

    Ford Fusion 2013–2020 Service Manual: Passenger Airbag. Removal and Installation


    Removal   WARNING: Turn the ignition OFF and wait one minute to deplete the backup power supply. Ignition must remain OFF until repair is complete. Failure to follow this instruction may result in serious personal injury or death in the event of an accidental deployment. If a SRS fault is present, continue to Step 2. Otherwise, turn the ignition OFF, wait at least one minute a..

    Categories

    Cross Traffic Alert System Sensors

    Ford Fusion. Cross Traffic Alert System Sensors

    The sensors are behind the rear bumper on both sides of your vehicle.

    read more

    Copyright © 2023 www.fofusion2.com