Ford Fusion: Climate Control System - General Information / Specifications
Lubricants, Fluids, Sealers and Adhesives
| Market | Item | Specifications |
|---|---|---|
| US, Canada | Motorcraft® R-1234yf Refrigerant PAG Oil / YN-35 | WSS-M2C300-A2 |
| Mexico | Motorcraft® PAG Refrigerant Compressor Oil / YN-12-D | WSH-M1C231-B |
| US, Canada | R-1234yf Refrigerant / YN-33-A (US); HS7Z-19B519-BA (Canada) | WSS-M17B21-A |
| Mexico | Motorcraft® R-134a Refrigerant / MYN-19 | WSH-M17B19-A |
| US, Canada, Mexico | Motorcraft® A/C System Flushing Solvent / YN-23 | — |
| US, Canada, Mexico | Motorcraft® A/C Cooling Coil Coating / YN-29 | — |
Capacities
| Market | Item | Specifications |
|---|---|---|
| US, Canada | Motorcraft® R-1234yf Refrigerant PAG Oil / YN-35 | 2.5L Duratec, 3.21 fl oz (95 ml); all others, 5.24 fl oz (155 ml) |
| Mexico | Motorcraft® PAG Refrigerant Compressor Oil / YN-12-D | |
| US, Canada | R-1234yf Refrigerant / YN-33-A (US); HS7Z-19B519-BA (Canada) | 1.5L EcoBoost, 18 oz (0.51 kg); 2.0L EcoBoost, 22 oz (0.62 kg); 2.5L Duratec, 22 oz (0.62 kg); 2.7L EcoBoost, 18 oz (0.51 kg) |
| Mexico | Motorcraft® R-134a Refrigerant / MYN-19 | 1.5L EcoBoost, 20 oz (0.57 kg); 2.0L EcoBoost, 24 oz (0.68 kg); 2.5L Duratec, 24 oz (0.68 kg); 2.7L EcoBoost, 20 oz (0.57 kg) |
A/C Compressor Clutch Air Gap
| mm | |
| A/C compressor clutch air gap | 0.35 — 0.60 |
Climate Control System - Vehicles With: Dual Automatic Temperature Control (DATC) - Component Location. Description and Operation
Item
Description
1
Sunload Sensor
2
Passenger Side Register Air Discharge Temperature Sensor
3
Passenger Side Footwell Air Discharge Temperature Sensor
4
Heating, Ventilation, and Air Conditioning (HVAC) Module
5
In-vehicle temperature & humidity Sensor
6
Driver Side Footwell Air Discharge Temperature Sensor
7
Dri..
Other information:
Ford Fusion 2013–2020 Service Manual: Front Drive Halfshafts. Diagnosis and Testing
Preliminary Inspection Visually inspect the CV joints, housing, boots, and clamps for obvious signs of mechanical damage. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step If the cause is not visually evident, verify the symptom and REFER to Symptom Chart: NVH. Symptom Chart(s) Diagn..
Ford Fusion 2013–2020 Service Manual: Generator Current Sensor. Removal and Installation
Removal Disconnect the battery ground. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables) . NOTE: 2.5L shown, other engines similar. NOTE: Note the orientation and position of the generator current sensor tape tab. Position the B+ wire protective cover and remove the nut. Index-mark the battery cable at the generator current sensor. Re..
Categories
- Manuals Home
- 2nd Generation Ford Fusion Owners Manual
- 2nd Generation Ford Fusion Service Manual
- Body Control Module (BCM). Removal and Installation
- Steering Column Control Module (SCCM). Removal and Installation
- Main Control Valve Body. Removal and Installation
- New on site
- Most important about car
Using Seatbelts During Pregnancy
WARNING: Always ride and drive with your seatback upright and properly fasten your seatbelt. Fit the lap portion of the seatbelt snugly and low across the hips. Position the shoulder portion of the seatbelt across your chest. Pregnant women must follow this practice. See the following figure.
Copyright © 2025 www.fofusion2.com