Ford Fusion: Driveshaft / Specifications

Ford Fusion 2013–2020 Service Manual / Chassis / Driveline / Driveshaft / Specifications

Driveshaft runout	1.0 mm (0.040 in)
Driveshaft to PTU joint angle @ curb ride height	5.259 degrees
Driveshaft center bearing "1" joint angle @ curb ride height (Center bearing closest to the PTU)	4.572 degrees
Driveshaft center bearing "2" joint angle @ curb ride height (Center bearing closest to the RDU)	1.635 degrees
Driveshaft to RDU joint angle @ curb ride height	0.929 degrees

Driveshaft

Driveshaft. Diagnosis and Testing

Preliminary Inspection Visually inspect the CV joints for obvious signs of mechanical damage. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step If the cause is not visually evident, verify the symptom and REFER to Symptom Chart: NVH...

Other information:

Ford Fusion 2013–2020 Service Manual: Roof Opening Panel Shield. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. On both sides, remove the A-pillar trim panel. Refer to: A-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation). On both sides, remove the B-pillar trim panel...

Ford Fusion 2013–2020 Service Manual: Piston Diameter. General Procedures

Check NOTE: Refer to the appropriate Section 303-01 for the specification. Measure the piston diameter 90 degrees from the piston pin and 41 mm (1.61 in) down from the top of the piston at the point indicated. ..

Parallel Parking

The system detects available parallel parking spaces and steers your vehicle into the space. You control the accelerator, gearshift and brakes. The system visually and audibly guides you into a parallel parking space.

Ford Fusion. Parallel Parking Press the button once to search for a parking space.