Ford Fusion: Chassis / Driveline

Vehicle Dynamics Control Module (VDM). Removal and Installation

Removal NOTICE: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result. NOTE: Removal steps in this procedure may contain installation details...

Driveshaft

..

Other information:

Ford Fusion 2013–2020 Service Manual: Wheel Studs. Removal and Installation

Special Tool(s) / General Equipment Hydraulic Press Removal Remove the wheel bearing and wheel hub. Refer to: Wheel Bearing and Wheel Hub - FWD (204-02 Rear Suspension, Removal and Installation). Refer to: Wheel Bearing and Wheel Hub - AWD (204-02 Rear Suspension, Removal and Installation). Press the wheel stud from the wheel bearing and wheel hub flange. U..

Ford Fusion 2013–2020 Service Manual: Refrigerant System Tests - 1.5L EcoBoost (118kW/160PS) – I4. General Procedures

Inspection NOTE: Procedure 1 — Ambient Temperature below 21 °C (70 °F). NOTE: Proper A/C system diagnosis on a vehicle’s compressor is dependent on correct refrigerant system charge and tested in ambient temperatures above 21°C (70°F). Perform the following steps to achieve normal operating pressures. Drive the vehicle or run the engine until it reaches normal operati..