Ford Fusion: Seatbelt Systems / Seatbelt Cleaning. General Procedures
Cleaning
WARNING:
Do not bleach or re-dye the seatbelt webbing, as the webbing
may weaken. Failure to follow this instruction may increase the risk of
serious personal injury or death in a crash.
-
Refer to the owner's literature for information on
seatbelt care and the recommended cleaning solution to use. Follow the
manufacturer's instructions provided with the cleaning solution.
Repair
NOTE:
If the seatbelt webbing does not extract from the seatbelt
retractor from the stowed position, this may be due to a normal
condition which happens when the seatbelt retracts at a high rate of
speed...
Inspection
WARNING:
All seatbelt components must be inspected and corrected as
part of any collision repair. Inspect all seatbelt components as
prescribed by Seatbelt Procedure After a Collision found in Section
501-20A General Procedures of this manual...
Other information:
Special Tool(s) /
General Equipment
205-153
(T80T-4000-W)
Handle
307-718Installer, Axle SealTKIT-2013B-FLTKIT-2013B-ROW
Puller
Punch
Removal
Remove the transfer case assembly.
Refer to: Power Transfer Unit (308-07B Power Transfer Unit - 6-Speed Automatic Transmission – 6F35, Removal)...
WARNING: Do not keep electrical
devices plugged in the power point
whenever the device is not in use. Do not
use any extension cord with the 110 volt
AC power point, since it will defeat the
safety protection design. Doing so may
cause the power point to overload due
to powering multiple devices that can
reach beyond the 150 watt load limit and
could result in fire or serious injury...