Ford Fusion: Steering System / Power Steering

Steering System

..

Power Steering - System Operation and Component Description. Description and Operation

System Operation System Diagram Item Description 1 EPAS gear 2 HS-CAN2 3 EPAS motor 4 EPAS motor position sensor 5 EPAS torque sensor 6 PSCM 7 PCM 8 SCCM 9 ABS module 10 BCM 11 PAM Network Message Chart   Module Network Input Messages: Power Steering Con..

Other information:

Ford Fusion 2013–2020 Service Manual: Refrigerant System Tests. General Procedures

Inspection NOTE: Procedure 1 — Ambient Temperature below 21 °C (70 °F). NOTE: Proper A/C system diagnosis on a vehicle’s compressor is dependent on correct refrigerant system charge and tested in ambient temperatures above 21°C (70°F). Perform the following steps to achieve normal operating pressures. Drive the vehicle or run the engine until it reaches normal operati..

Ford Fusion 2013–2020 Service Manual: Headlamp Control Module (HCM). Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: If installing a new module, it is necessary to upload the module configuration information to the scan tool prior to removing the module. This information must be downloaded into the new module after installation. Using a diagnostic scan tool, begin the PMI process for the HCM following the on..